The Influence of Finish Line Design on the Amount of Residual Cement in Implant-Supported Fixed Restorations

Authors

  • Đorđe Matović Faculty of Medicine, University of Priština-Kosovska Mitrovica Author

Keywords:

residual cement, finish line, cementation

Abstract

Introduction: Residual cement represents the excess cement that remains after cementation of implant-supported restorations, and it is directly associated with the development of peri-implantitis, one of the biological complications of implant prosthodontic therapy. Numerous factors can influence the occurrence of excess cement, such as the location of the finish line, the type of cement, and the cementation technique.

Aim: To investigate the influence of the finish line design of a prepared abutment on the amount of residual cement in implant-supported fixed restorations.

Material and methods: The study was conducted in vitro on printed working models obtained after implant placement under clinical conditions. Impressions were taken using a digital protocol. Prefabricated abutments prepared at the gingival level, 1.5 mm subgingivally, and 3mm subgingivally were used. Three finish line designs were tested: knife-edge, chamfer, and shoulder. The amount of residual cement was measured by photographic analysis. The models were photographed at the same distance using a holder custom-made for the purposes of the study. The cement surface area was measured in Adobe Photoshop. Statistical analysis was performed in SPSS.

Results: Comparative analysis of the results showed that the largest amount of residual cement was present with the knife-edge finish line located 3mm subgingivally (p=0.001). A significantly smaller amount of residual cement was observed when the abutment-crown junction was at the gingival level, regardless of the finish line design.

Conclusion: Finish line design may influence the amount of residual cement. A knife-edge finish line combined with a sungingival location may affect the direction, flow, and amount of residual cement.

Published

2026-11-18

Issue

Section

Abstracts