Influence of Disc Granulator Operating Parameters on the Granulation of Dolomite Stone Powder

Authors

  • Nina Galić Faculty of Mining, Geology and Petroleum Engineering, University of Zagreb Author

DOI:

https://doi.org/10.63356/

Keywords:

dolomite stone powder, granulation, disc granulator, operating parameters

Abstract

Introduction: Dolomite stone powder represents the finest fraction obtained from dolomite processing, consisting of particles smaller than 0.063 mm. Due to its very fine particle size, it is characterized by a high tendency to generate dust, difficulties in handling, transport and limited possibilities for direct application. During granulation, fine particles are bonded into more stable agglomerates – granules, improving their physical, mechanical and functional properties. The granulation process and the final properties of the granules are influenced by numerous factors, among which the operating parameters of the disc granulator play an important role.

The Aim: To investigate the influence of disc inclination angle, rotational speed and granulation time on the mean granule size (d₅₀), mass fraction of the 2–6 mm size class and compressive strength of the obtained granules.

Material and Methods: The experiments were conducted using a laboratory– scale disc granulator with dolomite stone powder and bentonite as the binder. An experimental design based on a Central Composite Design (CCD) was applied, resulting in 17 experiments with different combinations of disc inclination angle, rotational speed and granulation time. The influence of the selected parameters and their interactions on the physical and mechanical properties of the obtained granules was analysed.

Results: Granulation time had the greatest influence on mean granule size (d₅₀), with longer granulation resulting in smaller granules. Disc inclination angle had the greatest influence on granule strength due to its effect on material movement and collision intensity. No statistically significant influence of individual operating parameters on the mass fraction of the 2–6 mm size class was observed.

Conclusion: Achieving optimal granule properties requires a balanced combination of operating parameters. Improved physical and mechanical properties compared with the initial material confirm the potential of granulation for upgrading dolomite stone powder and increasing mineral resource utilization.

Published

2026-11-19

Issue

Section

Articles